Service Hotline:13808581953 

Your current location:Home > News > Company news
Company news

 When using cutting oil, prevent splashing by using appropriate splash guards. Cutting oil on the floor can cause a slippery condition that could result in operator injury.

Source:www.ptyxjx.comTime:2018-12-30Views:Loading...


    An efficient and positive method of holding workpieces to the milling machine table is important if the machine tool is to be used to its fullest advantage. The most common methods of holding are clamping a workpiece to the table, clamping a workpiece to the angle plate, clamping the workpiece in fixtures, holding a workpiece between centers, holding the workpiece in a chuck, and holding the workpiece in a vise. Regardless of the method used in holding, there are certain factors that should be observed in every case. The workpiece must not be sprung in clamping, it must be secured to prevent it from springing or moving away from the cutter, and it must be so aligned that it may be correctly machined T-slots. Milling machine worktables are provided with several T-slots which are used either for clamping and locating the workpiece itself or for mounting the various holding devices and attachments. These T-slots extend the length of the table and are parallel to its line of travel. Most milling machine attachments, such as vises and index fixtures, have keys or tongues on the underside of their bases so that they may be located correctly in relation to the T-slots.


Back

rXHHwDj6p159vd3eAan43OBLh3ajxul1r2kYwbdKsIUDCf0PG9ZIPQ65HL2EhpA1IRLLeaqZqDQhH2N6wucOmU1w63k7v4+E82C5rvJ34fBXzQOWP37daQ==